E A G L E

Button feeding device.

Programming Cyling Machine

 

1.加油方法

Refueling method

Regular refueling (white oil, sewing machine oil can be maintained).Refill half a bottle, not more than half a bottle

Click on the "already annotated" on the screen to resolve the screen alarm information.

 

extend their life. In addition, as long as the guideway is the place can often refueling lubrication.

 

Air valve push forward to open air valve


插入振动盘电源并固定牢以后放入机箱内。

 

打开电源
Turn on the power
 

打开电源,旋动旋扭调节振动盘速度。

 

刮料片调节
Sorting plate adjustment
 

Adjust the scraping height so that the buttons do not overlap.


调整过滤片为了能够正确选取所需扭扣的方向,一般扭扣调出约为扭扣大小的三分之二即可识别出正反。

the general button is about two-thirds of the size of the torsion to identify the positive and negative.

 

Pull up the pressure buckle block and put it on the buckle. The convex side is facing upwards. It must be ensured

 

轨道宽度调节
Adjust width
 

过大会使装扣不顺畅。

can pass smoothly, not too large (larger than the largest torsion buckle 0.1-0.2MM can),

 

挡扣位置调节
Left and right position regulation
 

对应屏幕操作

 

把纽扣放到大致中心位置,按下屏幕手动操作界面内的压扣,然后按下上料,再按下步进电机,让纽扣自动找中心,

Put the button in the approximate center position, press the screen to manually operate the button i

find the center, when the button catches into the button, turn off the step Motor, then adjust the position

挡扣位置调节非常重要,挡扣左右位置调节是使扭扣的中心与压扣橡皮和扣抓三点同心,三点不同心会出现装不上扭扣,请认真对待

is to make the center of the buckle be concentric with the deduction rubber and the buckle.

压扣高度调节

 

 

Press buckle rubber height to press buckle board as a reference to adjust, can not be too high,

 

扣抓选择
Die selection
 

The choice of clasping mould is based on the smooth insertion of the button.

 

更换扣抓
Replacing die
 

精密部件,此处禁止拆卸,私自拆卸后果自负。

更换扣抓模具只能拆模具头

 

纽夹调节
Manipulator control
 

The size of the clip can be adjusted to about 3mm larger than the button.

 

关闭气阀
Disconnect the air switch

向后拉即可关闭气阀,建议下班后关闭。

 

更换橡皮
Replace rubber
 

取出压扣限位螺丝

 

Remove the worn eraser with the power and air supply turned off.

安装上新的橡皮,注意不能用力直接压轨道,一定要用手托住轨道,不然会影响轨道精度。

Install a new eraser. Be careful not to press the track directly.

 

Install the pressure-buckle height limit screw and adjust the height.